Vermeer D9X13 tracks and undercarriage, sized 250x72x52 (250 mm wide × 72 mm pitch × 52 links). Made for bore setups, utility installs and pit-to-pit moves. Free freight, 24-month warranty.
What the numbers mean on a Vermeer D9X13
- 250x72x52 — 250 mm tread width (about 10"), 72 mm pitch, 52 links
Width is the tread face, pitch is the distance between drive lugs, and links is the count around the loop. All three have to match — a track one link off will not tension correctly no matter how close the width is.
Tread choice for the Vermeer D9X13
Size gets the track on the machine; tread decides how it works and how long it lasts. What we stock for this one:
- Directional — digging, trenching and slope work. The standard excavator tread
Parts we carry for the Vermeer D9X13
Tracks. Call for anything not shown online — we can usually source it.
How these wear
Drills sit still under load and travel short distances, so tracks usually age out from compound fatigue rather than mileage. Replace in pairs where you can: a new track running against a stretched one loads the drive unevenly and you will feel it in the steering.
Same track, other machines
Track size follows undercarriage geometry, not brand, so 250x72x52 shows up on machines from several makers. If you run any of these alongside the Vermeer D9X13, it is the same belt:
Not sure which you are running? Read the size off the inside of the old track, or call (850) 816-7898 and we will pull it off the machine record. The Track Finder works by make and model too.
