The Vermeer D23x30 runs a 300x52.5x74 track: 300 mm across the tread, 52.5 mm between links, 74 links around. Cut for bore setups, utility installs and pit-to-pit moves and shipped free to the lower 48.
What the numbers mean on a Vermeer D23x30
- 300x52.5x74 — 300 mm tread width (about 12"), 52.5 mm pitch, 74 links
Width is the tread face, pitch is the distance between drive lugs, and links is the count around the loop. All three have to match — a track one link off will not tension correctly no matter how close the width is.
Tread choice for the Vermeer D23x30
Size gets the track on the machine; tread decides how it works and how long it lasts. What we stock for this one:
- MX — mixed and hard surfaces. A durable general-duty excavator tread
Parts we carry for the Vermeer D23x30
Tracks. Call for anything not shown online — we can usually source it.
How these wear
Drills sit still under load and travel short distances, so tracks usually age out from compound fatigue rather than mileage. Replace in pairs where you can: a new track running against a stretched one loads the drive unevenly and you will feel it in the steering.
Same track, other machines
Track size follows undercarriage geometry, not brand, so 300x52.5x74 shows up on machines from several makers. If you run any of these alongside the Vermeer D23x30, it is the same belt:
- Bobcat 325
- Bobcat 325D
- Bobcat 325G
- Bobcat 328
- Bobcat 328E
- Bobcat X225
- Bobcat X325
- Bobcat X325D
- Bobcat X325G
- Bobcat X328
Not sure which you are running? Read the size off the inside of the old track, or call (850) 816-7898 and we will pull it off the machine record. The Track Finder works by make and model too.
