Replacement rubber tracks for the Bobcat 325G mini excavator in 300x52.5x74 — 300 mm wide, 52.5 mm pitch, 74 links. Built for digging, trenching, backfill and tight-quarters work, with free freight to the lower 48.
What the numbers mean on a Bobcat 325G
- 300x52.5x74 — 300 mm tread width (about 12"), 52.5 mm pitch, 74 links
Width is the tread face, pitch is the distance between drive lugs, and links is the count around the loop. All three have to match — a track one link off will not tension correctly no matter how close the width is.
Tread choice for the Bobcat 325G
Size gets the track on the machine; tread decides how it works and how long it lasts. What we stock for this one:
- MX — mixed and hard surfaces. A durable general-duty excavator tread
Parts we carry for the Bobcat 325G
Tracks. Call for anything not shown online — we can usually source it.
How these wear
Excavator undercarriages load one side hard on slew and travel, so link cracking usually shows up before the tread wears out. Replace in pairs where you can: a new track running against a stretched one loads the drive unevenly and you will feel it in the steering.
Same track, other machines
Track size follows undercarriage geometry, not brand, so 300x52.5x74 shows up on machines from several makers. If you run any of these alongside the Bobcat 325G, it is the same belt:
- Bobcat 325
- Bobcat 325D
- Bobcat 328
- Bobcat 328E
- Bobcat X225
- Bobcat X325
- Bobcat X325D
- Bobcat X325G
- Bobcat X328
- Bobcat X328E
Not sure which you are running? Read the size off the inside of the old track, or call (850) 816-7898 and we will pull it off the machine record. The Track Finder works by make and model too.
