Replacement rubber tracks for the Boxer 532DX mini track loader in 230x72x39 — 230 mm wide, 72 mm pitch, 39 links. Built for hardscape, landscape and tight-access work, with free freight to the lower 48.
What the numbers mean on a Boxer 532DX
- 230x72x39 — 230 mm tread width (about 9"), 72 mm pitch, 39 links
Width is the tread face, pitch is the distance between drive lugs, and links is the count around the loop. All three have to match — a track one link off will not tension correctly no matter how close the width is.
Tread choice for the Boxer 532DX
Size gets the track on the machine; tread decides how it works and how long it lasts. What we stock for this one:
- C-Block — concrete, asphalt and hard-packed ground. Longest wear life and the least vibration on hard surfaces
Undercarriage parts for the Boxer 532DX
Rollers, idlers and sprockets wear on the same clock as the track. Fitting new rubber over a hooked sprocket or a seized roller is the fastest way to lose the new track — check these while the tracks are off:
How these wear
Stand-on loaders spend their life on curbs, trailers and hard surfaces, so abrasion is the usual failure mode, not cracking. Replace in pairs where you can: a new track running against a stretched one loads the drive unevenly and you will feel it in the steering.
Same track, other machines
Track size follows undercarriage geometry, not brand, so 230x72x39 shows up on machines from several makers. If you run any of these alongside the Boxer 532DX, it is the same belt:
- Bobcat MT55
- Boxer 400
- Boxer 427
- Boxer 526DX
- Boxer 530DX
- Case TF300
- Case TF300RT
- Ditch Witch HT25
- Ditch Witch HT25K
- Ditch Witch JT1200
Not sure which you are running? Read the size off the inside of the old track, or call (850) 816-7898 and we will pull it off the machine record. The Track Finder works by make and model too.
