Canycom SC45 Rubber Tracks & Parts

The Canycom SC45 takes a 180 mm track, but it was built with more than one pitch — 60 and 72 mm. Same width, different drive-lug spacing, and they do not swap. Check the old track or the sprocket before ordering. Free freight to the lower 48, 24-month warranty.

Canycom SC45 track options

  • 180x72x39 — 180 mm (7") wide, 72 mm pitch, 39 links
  • 180x60x39 — 180 mm (7") wide, 60 mm pitch, 39 links

Same tread width on all of them — what changes is pitch and link count, which is set by the sprocket and roller frame. Read the numbers off the inside of the old track rather than going by model year; these were built across more than one undercarriage spec.

Tread choice for the Canycom SC45

Size gets the track on the machine; tread decides how it works and how long it lasts. What we stock for this one:

  • C-Block — concrete, asphalt and hard-packed ground. Longest wear life and the least vibration on hard surfaces
  • Directional — digging, trenching and slope work. The standard excavator tread

If the machine splits its time between surfaces, buy for the ground you are on most — a hard-surface tread on constant mud will spin, and a bar tread on concrete will wear out in half the hours.

Parts we carry for the Canycom SC45

Tracks. Call for anything not shown online — we can usually source it.

How these wear

Carriers run loaded over uneven ground, so link fatigue and guide-lug wear come before tread loss. Replace in pairs where you can: a new track running against a stretched one loads the drive unevenly and you will feel it in the steering.

Same track, other machines

Track size follows undercarriage geometry, not brand, so one of these sizes shows up on machines from several makers. If you run any of these alongside the Canycom SC45, it is the same belt:

Not sure which you are running? Read the size off the inside of the old track, or call (850) 816-7898 and we will pull it off the machine record. The Track Finder works by make and model too.

More Canycom undercarriage

Free US Shipping100% Fit GuaranteePremium OEM Quality

Shop Parts
Canycom SC45 — TrackTECH rubber tracks & undercarriage parts

Track sizes

Heavy-Duty Rubber Tracks for SC45

  • 180x60x39 Heavy Duty Rubber Track | Directional
    Canycom SC45 180x60x39 Directional
    • Heavy Duty | 180x60x39
    $202.80$195.00

    In stock

    Add to quote
  • 180x72x39 Heavy Duty Rubber Track | Directional
    Canycom SC45 180x72x39 Directional
    • Heavy Duty | 180x72x39
    $235.30$226.25

    In stock

    Add to quote
  • 180x72x39 Heavy Duty Rubber Track | C-Block
    Canycom SC45 180x72x39 C-Block
    • Heavy Duty | 180x72x39
    • Maximum Durability
    • Anti-Vibration
    • Cut & Tear Resistant
    $235.30$226.25

    In stock

    Add to quote

Which tread fits Canycom SC45?

Pick a tread for your jobsite — then buy above.
+ Recommended surface- Not the primary use— Application dependent
PatternBest UseKey TraitsRoadClayGravelMulchMudTurfAction
C-Block C-BlockHeavy-duty durability Built for maximum durability on abrasive jobsites, hard-pack surfaces, demolition debris, and mixed gravel.
  • Maximum Durability
  • Anti-Vibration
  • Cut & Tear Resistant
+++---View

  • 100% Virgin Rubber

    Engineered to resist chunking, tearing, and cutting in harsh, abrasive environments.

  • Continuous Steel Cords

    Jointless internal cable architecture eliminates structural weak points and maximizes overall tensile strength.

  • Drop-Forged Links

    Precision heat-treated guide lugs ensure exact sprocket engagement and prevent de-tracking under heavy side-loads.

  • Corrosion Resistant

    The internal steel framework is fully encapsulated to prevent oxidation, rust, and moisture penetration.

  • Reinforced Sidewalls

    Extra-thick vulcanized rubber and tapered edge profiles protect against curb slashing and lateral impacts from jobsite debris.

  • Low-Vibration Tread

    Optimized lug spacing and pitch geometry absorb shock, reducing undercarriage wear and minimizing cabin vibration.

Canycom SC45 Rubber Tracks & Parts fitment data

Verified-fit rubber tracks and undercarriage parts for the Canycom SC45. Confirm size and tread before ordering.

Frequently Asked Questions

What size rubber tracks fit a Canycom SC45?
The Canycom SC45 can use 180x60x39 or 180x72x39 rubber tracks. Match the full size on the track you are replacing before you order. If your machine has more than one track setup, choose the width and guide style that matches the track currently on the machine.